Hardware Setup

Internal Setup

Battery

The Foenix uses an internal CR2 battery to power the Real Time Clock chip. The battery is not presently required.

DIP Switches

The standard kernel interprets the DIP switches as follows:

• 1 - Boot option
• 2 - Boot option
• 3 - User definable
• 4 - User definable
• 5 - User definable
• 6 - off = 640x480; on = 800x600
• 7 - Gamma correction on/off
• 8 - IDE Drive installed

Boot options:

2	1	effect
off	off	Boot to BASIC
off	on	Boot from SD Card
on	off	Boot from floppy
on	on	Boot from HD

Hard Drive Installation

The Foenix FMX supports the installation of an internal hard-drive. You will need the following:

• A short IDE 44 Pin 2.5" laptop HDD Female-to-Female cable,eg:
  • https://www.ebay.ca/itm/IDE-44-Pin-2-5-laptop-HDD-Female-to-Female-Hard-Drive-Cable-F-F-5cm-2-inch-198-/170999956350
  • Or make your own:
    • https://www.digikey.ca/product-detail/en/3m/3625-44-30M/3M158022-1-ND/9479331
    • https://www.digikey.ca/product-detail/en/sullins-connector-solutions/SFH21-PPPN-D22-ID-BK-M181/S9083-ND/1989812
• You will need Standoff, M3, 12mm high with male on one end, and female on the other
  • https://www.mcmaster.com/93655a099
• M3 screws

Enclosures

The Foenix may be purchased as a bare board or packaged in a 3D printed enclosure; see: https://c256foenix.com/

Screws

The standard case uses the following screws:

• M2 Inserts, M3 inserts (2 Kind, 1 style for Bumpon, 1 style for PCB installation, M3 screws for Bumpon and PCB installation
• M2 screws for Polycarbonate Windows
• 1 screw for the RCA Connector in the back
• M2.5x8mm for Floppy Installation

Printing your own Enclosure

You may also print your own; the official STL files are here:

• https://cdn.discordapp.com/attachments/575557477018632213/676200823990255656/Official_Release_STL_Models_C256FOENIX_FMX.rar

In order to complete the enclosure, you will need inserts for plastic, M3/M2. You will need screws, and some Lexan cut out to complete the windows