Difference between revisions of "FMX Errata"
Jump to navigation
Jump to search
(Created page with "= Errata: Known Issues with the Board or Firmware = ; Errata 1---MIDI IN Port Pin Inversion (25/03/2020) : Pins 6 and 7 on the MIDI IN port of the RevC4A and RevC4B are rever...") |
(→Errata: Known Issues with the Board or Firmware) |
||
| Line 2: | Line 2: | ||
; Errata 1---MIDI IN Port Pin Inversion (25/03/2020) | ; Errata 1---MIDI IN Port Pin Inversion (25/03/2020) | ||
| − | : Pins 6 and 7 on the MIDI IN port of the RevC4A and RevC4B are reversed. Plugging a device into the MIDI IN port will result in a short from +5V to ground. The board can be fixed by cutting | + | : Pins 6 and 7 on the MIDI IN port of the RevC4A and RevC4B are reversed. Plugging a device into the MIDI IN port will result in a short from +5V to ground. The board can be fixed by cutting three traces (marked in blue in the diagram below), and then soldering two jumper wires (shown in orange). Instead of cutting the two traces, the pin connected to pad 7 in the diagram below could be lifted from the pad. |
[[File:BoardErrata1.png|600px]] | [[File:BoardErrata1.png|600px]] | ||
Revision as of 17:38, 25 March 2020
Errata: Known Issues with the Board or Firmware
- Errata 1---MIDI IN Port Pin Inversion (25/03/2020)
- Pins 6 and 7 on the MIDI IN port of the RevC4A and RevC4B are reversed. Plugging a device into the MIDI IN port will result in a short from +5V to ground. The board can be fixed by cutting three traces (marked in blue in the diagram below), and then soldering two jumper wires (shown in orange). Instead of cutting the two traces, the pin connected to pad 7 in the diagram below could be lifted from the pad.
